All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the overhead console bezel.
- Release the locking tabs while pulling down.
Fig 1: Removing Overhead Console Bezel
Courtesy of FORD MOTOR CO.
Remove the screws and the left and right visors.
- If equipped, disconnect the electrical connector.
Fig 2: Locating Left And Right Visors Screws
Courtesy of FORD MOTOR CO.
Position the left and right front door opening weatherstripping down from the headliner.

Fig 3: Positioning Left And Right Front Door Opening Weatherstrips Down From Headliner
Courtesy of FORD MOTOR CO.
Remove the left and right windshield side garnish moulding. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.

NOTE: SuperCab shown, Regular Cab and Crew Cabs similar.

NOTE: Crew Cab vehicles are equipped with 2 courtesy lamps.

Fig 4: Removing Courtesy Lamp

Courtesy of FORD MOTOR CO.

Remove the courtesy lamp(s).
- Remove the courtesy lamp lens, then remove the screws.

NOTE: Regular Cab shown, SuperCab and Crew Cabs similar.

Fig 5: Locating Scuff Plate(s)

Courtesy of FORD MOTOR CO.

Remove the scuff plate(s).

Remove the 2 headliner rear pin-type retainers.

Fig 1: Locating Headliner Rear Pin-Type Retainers
Courtesy of FORD MOTOR CO.
Remove the LH and RH shoulder safety belt guides.
- Position the shoulder safety belt guide cover up.
- Remove the shoulder safety belt guide nut.
  - To install, tighten to 40 N.m (30 lb-ft).
- Remove the shoulder safety belt guide.
Fig 2: Identifying Shoulder Safety Belt Guide
Courtesy of FORD MOTOR CO.
Position the LH and RH B-pillar trim panels aside.

Fig 3: Positioning Aside B-Pillar Trim Panels
Courtesy of FORD MOTOR CO.
If equipped, remove the assist handle(s).
- Remove the covers and bolts.
- Remove the assist handle.
Fig 4: Identifying Assist Handle Covers And Bolts
Courtesy of FORD MOTOR CO.

NOTE: Typical shown.

Fig 5: Locating Coat Hooks

Courtesy of FORD MOTOR CO.

Remove the 2 coat hooks.
Remove the 2 headliner front pin-type retainers and position the headliner aside.

Fig 6: Locating Headliner Front Pin-Type Retainers
Courtesy of FORD MOTOR CO.

NOTE: Pull down at the front of the bracket first.

Fig 7: Removing Overhead Console

Courtesy of FORD MOTOR CO.

Remove the overhead console bracket.
- Disconnect the electrical connector.
To install, reverse the removal procedure.