Both seats
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Fold the second row 40 and 60 percent seat backrest FORWARD.
- Remove the safety belt buckle(s) and lap belt assembly from between the seat backrest and cushion.
NOTE: The remaining steps of the procedure are shown with the second row seat removed for clarity. - Remove the wing nut and the jack tools.
- Remove the 3 bolts and the jack assembly compartment.
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. For additional information, refer to Safety Belt System in this article.
NOTE:
When installing a new safety belt buckle and lap belt assembly, make sure to install it at the second row right hand position of the vehicle. This is due to the safety belt buckles and tongues being different sizes from the left hand to the right hand side.
NOTE:
Make sure the safety belt webbing is not twisted prior to installation.
NOTE:
Make sure the safety belt buckle and lap belt are positioned between the seat backrest and cushion and accessible to the passengers after installation.