Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the RH heated oxygen sensor (HO2S). For additional information, refer to ELECTRONIC ENGINE CONTROLS article.
- Detach the exhaust manifold-to-exhaust gas recirculation (EGR) system module tube from the exhaust manifold and the EGR system module and remove the tube.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.