LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 603 (Seat System - F-150 & Mark LT) >> Disassembly And Assembly >> Seat Cushion - Rear >> Disassembly And Assembly >> 60 percent seat

60 percent seat

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 60 percent support riser bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  2. Remove the 60 percent support riser pivot bolt and bushing.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the left support riser.
  4. Remove the 60 percent seat cushion latch handle screw and handle.
  5. Remove the 60 percent seat cushion latch cover screw and cover.
  6. Remove the 60 percent seat latch cushion bolt and latch.
    • To install, tighten to 30 Nm (22 lb-ft).
    7. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat cushion foam pad.
    Fig 1: Separating Hook-And-Loop Fasteners
    GF0001927Courtesy of FORD MOTOR CO.
  7. Separate the hook-and-loop fasteners.
  8. Remove the 60 percent cushion trim cover.
    • Remove the hog rings and remove the seat trim cover.
    Fig 2: Removing 60 Percent Cushion Trim Cover
    GF0001928Courtesy of FORD MOTOR CO.
  9. Remove the 60 percent cushion foam pad.
  10. Remove the 60 percent inboard pivot bushing.
scientia non olet · About LEMON Manuals