LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 603 (Seat System - F-150 & Mark LT) >> Disassembly And Assembly >> Seat Cushion - Rear >> Disassembly And Assembly >> 40 percent seat

40 percent seat

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 40 percent support riser bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  2. Remove the 40 percent support riser pivot bolt, bushing and right support riser.
    • To install, tighten to 40 Nm (30 lb-ft).
  3. Remove the 40 percent seat cushion latch handle screw and handle.
  4. Remove the 40 percent seat cushion latch cover screw and cover.
  5. Remove the 40 percent seat cushion latch bolt and latch.
    • To install, tighten to 30 Nm (22 lb-ft).
    6. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the seat cushion foam pad.
    Fig 1: Separating Hook-And-Loop Fasteners
    GF0001929Courtesy of FORD MOTOR CO.
  6. Separate the hook-and-loop fasteners.
  7. Remove the 40 percent trim cover.
    • Remove the hog rings and remove the seat trim cover.
    Fig 2: Removing 40 Percent Trim Cover
    GF0001930Courtesy of FORD MOTOR CO.
  8. Remove the 40 percent foam pad.
  9. Remove the 40 percent inboard pivot bushing.
scientia non olet · About LEMON Manuals