LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Engine Cooling System - F-150 & Mark LT) >> Removal And Installation >> Radiator >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding  in this article.
  2. Remove the cooling fan and shroud. For additional information, refer to Cooling Fan - Blade, Clutch and Shroud  in this article.
  3. Release the clamp and disconnect the upper radiator hose.
  4. Release the clamp and disconnect the upper degas bottle hose.
  5. Release the clamp and disconnect the lower radiator hose.
  6. Using the special tool, disconnect the transmission cooler tubes.
    7. Fig 1: Disconnecting Transmission Cooler Tubes By Using Special Tool
    GF0002827Courtesy of FORD MOTOR CO.
  7. Remove the bolts, the radiator support brackets and the upper radiator insulators
    • To install, tighten to 30 N.m (22 lb-ft).
  8. Remove the radiator.
  9. Remove the lower radiator insulators.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals