LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Engine Ignition - 2.3L >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the ignition coil electrical connectors.
  3. Remove the bolts and the ignition coils.
    • To install, tighten to 8 Nm (71 lb-in).
  4. To install, reverse the removal procedure.
    • Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
scientia non olet · About LEMON Manuals