LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 847 (Parking Brake System & Actuation -- F250-F550 Super Duty) >> Removal And Installation >> Parking Brake Shoes >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. For additional information, refer to REAR DISC BRAKE article.
  2. Release the tension on the parking brake system. For additional information, refer to Parking Brake Cable Tension Release  in this article.
  3. Release the parking brake cable from the parking brake bracket assembly.
    Fig 1: Locating Parking Brake Cable At LH Bracket Assembly
    G03919405Courtesy of FORD MOTOR CO.
  4. Rotate the parking brake cable 90 degrees to release it from the parking brake actuating lever.
    Fig 2: Locating Parking Brake Actuating Levers
    G03919392Courtesy of FORD MOTOR CO.
  5. Remove the 2 brake shoe hold-down clips and the 2 brake shoe retaining pins.
  6. Remove the brake shoe adjusting screw and the lower brake shoe retaining spring.
  7. Remove the brake shoes and the upper brake shoe retaining spring.
  8. To install, reverse the removal procedure.
    • Inspect the components for excessive wear or damage and install new as required.
scientia non olet · About LEMON Manuals