Torque Specifications
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Battery ground wire | 23 | 17 | - |
| Digital transmission range (TR) sensor bolts | 9 | - | 80 |
| Electrical pressure control (EPC) solenoid bolt | 10 | - | 89 |
| Exhaust bracket nut | 12 | 9 | - |
| Exhaust hanger bolts | 40 | 30 | - |
| Exhaust heat shield-to-crossmember bolt | 15 | 11 | - |
| Extension housing bolts | 27 | 20 | - |
| Front driveshaft bolts | 103 | 76 | - |
| Front driveshaft shield nuts | 18 | 13 | - |
| Front pump bolts | 27 | 20 | - |
| Front pump support bolts | 23 | 17 | - |
| Fuel line bracket nut | 25 | 18 | - |
| Harness electrical connector bolt | 5 | - | 44 |
| Inspection cover bolts | 34 | 25 | - |
| Main control valve body boltsa | - | - | - |
| Main control valve body cover plate boltsa | - | - | - |
| Main control valve body reinforcement plates | 10 | - | 89 |
| Manual control valve detent lever spring bolt | 10 | - | 89 |
| Manual lever shaft inner nut | 31 | 23 | - |
| Manual lever shaft outer nut | 33 | 24 | - |
| Output shaft speed (OSS) sensor bolt | 12 | 9 | - |
| Pressure tap plugs | 10 | - | 89 |
| Rear driveshaft bolts | 103 | 76 | - |
| Selector lever cable bracket bolts | 25 | 18 | - |
| Starter bolts | 26 | 19 | - |
| Starter electrical connector | 12 | 9 | - |
| Starter electrical connector (small terminal) | 6 | - | 53 |
| TCC solenoid bolt | 10 | - | 89 |
| Torque converter nuts | 36 | 27 | - |
| Transmission case retaining bolts | 48 | 35 | - |
| Transmission crossmember bolts | 115 | 85 | - |
| Transmission filter tube bolt | 12 | 9 | - |
| Transmission fluid cooler tube case fittings | 31 | 23 | - |
| Transmission fluid cooler tube nut fittings | 27 | 20 | - |
| Transmission fluid pan bolts | 14 | 10 | - |
| Transmission insulator bolts | 80 | 59 | - |
| Transmission insulator nuts | 103 | 76 | - |
| Transmission vent | 20 | 15 | - |
| Turbine shaft speed (TSS) sensor bolt | 11 | 8 | - |
a Specific tightening sequence is required. See the procedure in this article.