LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Freestyle SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (Automatic Transmission - 4R70E/4R75E - F150 & Mark LT) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the output shaft speed (OSS) sensor electrical connector.
  3. Remove the OSS sensor bolt and sensor.
    • Remove the OSS sensor bolt.
    • Remove the OSS sensor.
  4. To install, reverse the removal procedure.
    • Tighten bolt to 12 Nm (9 lb-ft).
scientia non olet · About LEMON Manuals