LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Freestyle SEL, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (Automatic Transmission - 4R70E/4R75E - F150 & Mark LT) >> Disassembly And Assembly Of Subassemblies >> Main Control Valve Body >> Disassembly

Main Control Valve Body: Disassembly

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Main Control Valve Body Disassembled View
GF0003598Courtesy of FORD MOTOR CO.
Item Part Number Description
1 - Valve plug retainer (part of 7A100)
2 - Main pressure booster valve sleeve (part of 7A100)
3 - Main pressure booster valve (part of 7A100)
4 - Main pressure regulator valve spring (part of 7A100)
5 - Main regulator valve (part of 7A100)
6 7A100 Main control valve body assembly
7 7E195 Check ball (8 required)
8 7H171 Converter drain back valve
9 - Pressure regulator valve (part of 7A100)
10 - Pressure regulator valve spring (part of 7A100)
11 - Regulator boost plunger (part of 7A100)
12 - Regulator boost sleeve (part of 7A100)
13 - Valve retainer (part of 7A100)
14 - Capacity modulator valve (part of 7A100)
15 - Capacity modulator valve spring (part of 7A100)
16 - Spring retaining plate (part of 7A100)
17 - Capacity modulator valve (part of 7A100)
18 - Capacity modulator valve spring (part of 7A100)
19 - Spring retaining plate (part of 7A100)
20 - 3-4 shift valve (part of 7A100)
21 - 3-4 shift valve spring (part of 7A100)
22 - Valve retainer plug (part of 7A100)
23 - Valve plug retainer (part of 7A100)
24 - 2-3 back out valve (part of 7A100)
25 - 2-3 back out valve spring (part of 7A100)
26 - Spring retaining plate (part of 7A100)
27 - Spring retaining plate (part of 7A100)
28 - Pressure regulator valve spring (part of 7A100)
29 - Pressure regulator valve (part of 7A100)
30 - Control manual valve (part of 7A100)
31 - Retaining ring (part of 7A100)
32 - Solenoid screen
33 - 1-2 shift valve (part of 7A100)
34 - 2-3 shift valve spring (part of 7A100)
35 - 2-3 valve (part of 7A100)
36 - Valve retaining plug (part of 7A100)
37 - Valve plug retainer (part of 7A100)
38 - Spring retaining plate (part of 7A100)
39 - Pressure regulator valve spring (part of 7A100)
40 - Pressure regulator valve (part of 7A100)
41 - Bypass clutch control valve (part of 7A100)
42 - Bypass clutch control valve spring (part of 7A100)
43 - Bypass clutch control valve plunger (part of 7A100)
44 - Bypass clutch control plunger sleeve (part of 7A100)
45 - Control valve plate (part of 7A100)
  1. Remove the torque converter clutch (TCC) solenoid and the shift solenoid.
    • Remove the retaining bolt.
    • Remove the shift solenoid.
    • Remove the TCC solenoid.
  2. Fig 2: Identifying Torque Converter Clutch (TCC) Solenoid & Shift Solenoid
    GF0003599Courtesy of FORD MOTOR CO.
  3. Remove the 2 reinforcement plate and bolts.
  4. Fig 3: Locating Reinforcement Plate And Bolts
    GF0003600Courtesy of FORD MOTOR CO.
  5. Remove the separator plate and discard the gaskets.
  6. Fig 4: Locating Separator Plate
    GF0003601Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the eight coasting booster valve shuttle balls for assembly.
    Fig 5: Locating Coasting Booster Valve Shuttle Balls
    GF0003602Courtesy of FORD MOTOR CO.
    Item Part Number Description
    1 7E195 Check ball (B9) located in the forward clutch circuit near the 3-4 shift valve
    2 7E195 Check ball (B2) located in the direct clutch circuit near the 2-3 backout valve
    3 7E195 Check ball (B3) located in the overdrive and forward clutch circuits near the 1-2 shift valve
    4 7E195 Check ball (B4) located in the reverse circuit near the orifice 1
    5 7E195 Check ball (B5) located between the reverse, LS modulator and the low reverse servo circuits
    6 7E195 Check ball (B6) located between the L, 2, 3, 4 and the torque converter clutch (TCC) circuits
    7 7E195 Check ball (B7) located between the L, 2, 3, 4 and the intermediate clutch circuits
    8 7E195 Check ball (B8) located between the forward clutch and the 23 BP circuits
  7. Remove the 8 coasting booster valve shuttle balls.
  8. Remove the converter drain back valve and solenoid pressure supply screen.
  9. Fig 6: Locating Converter Drain Back Valve And Solenoid Pressure Supply Screen
    GF0003603Courtesy of FORD MOTOR CO.
  10. Remove the main control valve body cover plate.
    • Remove the 13 main control valve body cover plate bolts.
    • Remove the main control valve body cover plate.
  11. Fig 7: Identifying Main Control Valve Body Cover Plate
    GF0003604Courtesy of FORD MOTOR CO.