Removal and Installation
WARNING:
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Disconnect the battery. For additional information, refer to CHARGING SYSTEM - GENERAL INFORMATION .
- Remove the air cleaner assembly. For additional information, refer to FUEL CHARGING & CONTROLS .
- Use a suitable suction device to drain the reservoir before removal.
- Disconnect the brake fluid level switch electrical connector.
- Remove the brake fluid reservoir retaining pin.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the brake fluid reservoir.
- Remove the brake fluid level switch.
- To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .