LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Freestar S >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine - 5.4L (3V) - F250-F550 Super Duty) >> In-Vehicle Repair >> Engine Support Insulators >> Removal

Engine Support Insulators: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT .
  3. Remove the air cleaner housing. For additional information, refer to AIR CLEANER -- 5.4L (3V) .
  4. Remove the generator. For additional information, refer to GENERATOR -- GASOLINE ENGINES .
  5. Remove the cooling fan shroud. For additional information, refer to COOLING FAN -- BLADE, CLUTCH AND SHROUD .
  6. If removing the RH engine support insulator, remove the starter. For additional information, refer to STARTER MOTOR .
  7. Install the special tools.
    Fig 1: Installing Special Tools
    G04647876Courtesy of FORD MOTOR CO.
  8. Remove the 4 exhaust manifold-to-catalytic converter nuts.
    Fig 2: Locating Exhaust Manifold-To-Catalytic Converter Nuts
    G03920889Courtesy of FORD MOTOR CO.
    9. CAUTION: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
    Fig 3: Identifying Transmission Mount-To-Crossmember Nuts
    G03963913Courtesy of FORD MOTOR CO.
  9. Loosen the transmission mount-to-crossmember nuts.
    10. CAUTION: Only use hand tools when removing the engine mount nut or damage to the engine mount can occur.
    NOTE: RH shown, LH similar.
    Fig 4: Identifying Engine Mount Nuts
    G03919938Courtesy of FORD MOTOR CO.
  10. Remove the 6 engine mount nuts.
  11. Using the special tools, raise the engine.
    Fig 5: Installing Special Tools
    G04647876Courtesy of FORD MOTOR CO.

    12. RH engine mount 

  12. Remove the 4 bolts and the engine mount.
    Fig 6: Removing Bolts And Engine Mount
    G03920168Courtesy of FORD MOTOR CO.
  13. Remove the 4 bolts and the engine mount bracket.
    Fig 7: Removing Bolts And Engine Mount Bracket
    G03920165Courtesy of FORD MOTOR CO.

    14. LH engine mount 

  14. Remove the 3 bolts and the engine mount.
    Fig 8: Removing Bolts And Engine Mount
    G03920166Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals