LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Freestar Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Removal And Installation >> Brake Pedal Motor

Brake Pedal Motor

  1. Remove the 3 steering column opening cover bolts and the cover.
    • To install, tighten to 8 Nm (71 lb-in).
  2. Remove the 2 steering column opening reinforcement bolts and the reinforcement.
    • To install, tighten to 8 Nm (71 lb-in).
  3. Remove the demister duct.
  4. Remove the 2 adjustable pedal motor bolts and release the drive cable assembly from the adjustable pedal motor.
    • To install, tighten to 2 Nm (18 lb-in).
  5. Disconnect the adjustable pedal motor electrical connector.
  6. Remove the adjustable pedal motor.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals