LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Freestar Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System Actuation >> Removal And Installation >> Brake Pedal Motor Cable

Brake Pedal Motor Cable

  1. Remove the 3 steering column opening cover bolts and the cover.
    • To install, tighten to 8 Nm (71 lb-in).
  2. Remove the 2 steering column opening reinforcement bolts and the reinforcement.
    • To install, tighten to 8 Nm (71 lb-in).
  3. Remove the demister duct.
  4. Disconnect the drive cable assemblies from the accelerator and brake pedals.
  5. Remove the 2 adjustable pedal motor bolts and release the cable assembly from the adjustable pedal motor.
    • To install, tighten to 2 Nm (18 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals