| 215 - ELECTRICAL ROUTINE |
| Powertrain Control System |
- Electrical Inputs/Outputs, Vehicle Wiring Harnesses, Powertrain Control Module (PCM), Shift Solenoids (SSA, SSB, SSC), OSS Sensor, Internal Wire Harness
|
- Run On-Board Diagnostic. See INTRODUCTION - GASOLINE
article for diagnosis. GO to PINPOINT TEST A using the Transmission Tester. Repair as required. If DTC P1700 is present, check for a low transaxle fluid level, then continue to Hydraulic/Mechanical Routines. Clear codes. Road Test and rerun On-Board Diagnostic.
|
| 315 - HYDRAULIC/MECHANICAL ROUTINE |
| Main Control Valve Body |
- Bolts out of torque specification
|
- Tighten bolts to specification.
|
- Gaskets and Separator Plate - damaged, off location
|
- Inspect for damage. Replace as required.
|
- Shift Valves, Forward Clutch Control Valve, Springs, Clips - stuck, damaged, missing, misassembled
|
- Inspect for damage. Install a new as required.
|
- Shift Solenoid - stuck, damaged
|
- Inspect for damage. GO to PINPOINT TEST A . Repair as required. Activate solenoid using a Transmission Tester. If solenoid operation cannot be felt when placing hand on solenoid, replace solenoid. Inspect O-rings for damage. Install a new as required.
|
- For diagnosis related to a specific gear, use the transmission tester to select the gear
|
- See the following routines:
- Shift 1-2, Routine 220/320
- Shift 2-3, Routine 221/321
- Shift 3-4, Routine 222/322
|
| Mechanical |
|
|
- Inspect for damage. Install a new as required.
|
- Bands, Clutches or Seals - damaged or worn
|
- Inspect for damage. Install a new as required.
|