LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Focus ZX5 S, Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Seat Belts >> Safety Belt System >> General Procedures >> Safety Belt Tongue Rotated on Belt

Safety Belt Tongue Rotated on Belt

  1. Grasp the belt tongue and pull the belt webbing down to form a loop through the upper (longer and narrower) slot in the tongue.
  2. Rotate and fold the belt webbing over itself within the slot to remove the twist.
    Fig 1: Rotating And Folding Belt Webbing Over Itself Within Slot To Remove Twist
    G03880888Courtesy of FORD MOTOR CO.
  3. Pull the excess belt webbing back through the upper slot in the belt tongue.
  4. Grasp the belt tongue and pull the belt webbing up to form a loop through the lower slot in the tongue.
  5. Rotate and fold the belt webbing over itself within the slot to remove the twist.
  6. Pull the excess belt webbing through the slot.
    Fig 2: Pulling Excess Belt Webbing Through Slot
    G03953314Courtesy of FORD MOTOR CO.
    7. NOTE: Dual slot tongue shown, single slot tongue similar.
    Fig 3: Identifying Safety Belt Tongue Is Facing Inward
    G03953315Courtesy of FORD MOTOR CO.
  7. The safety belt tongue should face inward when completed.
scientia non olet · About LEMON Manuals