Removal and Installation

Remove the antenna mast from the base.

Fig 1: Removing Antenna Mast From Base
Courtesy of FORD MOTOR CO.
Remove the interior lamp.
- Disconnect the interior light electrical connector.
Fig 2: Removing Interior Lamp
Courtesy of FORD MOTOR CO.
Remove the interior lamp bezel.

Fig 3: Removing Interior Lamp Bezel
Courtesy of FORD MOTOR CO.
If equipped, remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the antenna cable/base retaining screw.

Fig 4: Removing Antenna Cable/Base Retaining Screw
Courtesy of FORD MOTOR CO.
Remove the antenna base.

Fig 5: Removing Antenna Base
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.