Turn Signal Lamps and Hazard Warning Lamps

The turn signal lamps and hazard warning lamps system consists of:

• Hazard switch
• Multifunction switch
• GEM
• Turn signal lamps

When the multifunction switch is placed in the LH or RH turn positions, a voltage signal from the GEM is routed to ground. When the GEM detects the multifunction switch in the LH or RH turn position, the GEM supplies voltage to the appropriate turn lamps in a flashing manner. When operating correctly, the turn lamps flash approximately 80 times per minute.

When the hazard warning switch (located in the upper part of the center console) is switched on, a voltage signal from the GEM is routed to ground. When the GEM detects that the hazard switch is switched on, the GEM supplies voltage to all the turn signal lamps in a flashing manner. When operating correctly, the hazard lamps flash approximately 80 times per minute.