LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Excursion 6.8 S, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Exterior Trim And Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Running Board >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
    2. NOTE: Left side SuperCab shown, regular cab, Crew Cab and tube running board similar. Right side symmetrically opposite.
    NOTE: Make sure to disconnect the running board lights electrical connector, if equipped.
  2. Remove the running board.
    • Remove the bolts.
      • To install, tighten to 23 N.m (17 lb-ft).
    • Remove the running board.
    3. Fig 1: Locating Running Board Bolts
    GF0004885Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals