LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pan >> Removal

Oil Pan: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the exhaust flexible pipe. For additional information, refer to JACKING AND LIFTING .
  3. Drain the engine oil and install the drain plug.
    • Tighten to 26 Nm (19 lb-ft).
  4. Remove and discard the oil filter.
    5. NOTE: For reference during installation, mark the location of the stud bolts.
  5. Remove the 10 bolts, 5 stud bolts and the oil pan.
    • Remove and discard the oil pan gasket.
scientia non olet · About LEMON Manuals