LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Detach the upper radiator hose pin-type retainer from the radiator core support and position the hose aside.
  2. Remove the 4 upper radiator support bracket bolts and the 2 brackets.
    • To install, tighten to 10 Nm (89 lb-in).
  3. Remove the oil level indicator.
  4. Remove the stud bolt and then remove the oil level indicator tube by guiding it between the radiator core support and the cooling fan.
    • Remove and discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    5. NOTE: Install a new O-ring seal and lubricate with clean engine oil.
    NOTE: Installation of the oil level indicator may require the assistance of a second technician to align the tube with the orifice.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals