LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the flexplate. For additional information, refer to FLEXPLATE .
  3. Using the special tools, remove and discard the crankshaft rear oil seal.
    Fig 1: Removing Crankshaft Rear Oil Seal
    G03898286Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals