DTC P1309: Misfire Monitor Disabled
WARNING: This page is about a different variant/trim than selected.
P1309 - MISFIRE MONITOR DISABLED
| Description: | When the misfire monitor is disabled, usually due to the input signal generated by the camshaft position (CMP) sensor, by sensing the passage of teeth from the CMP wheel. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the CMP sensor is installed correctly and is not out of synchronization. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | - | - | GO to HD: Misfire Detection Monitor STEP HD30. |