Recreating the Fault
WARNING: This page is about a different variant/trim than selected.
Recreating the fault is the first step in isolating the cause of the intermittent symptom. A thorough investigation should start with the customer information worksheet located in the Introduction. If freeze frame data is available, it may help in recreating the conditions at the time of a malfunction indicator lamp diagnostic trouble code (MIL DTC). Listed below are some of the conditions for recreating the fault:
RECREATE FAULT - CONDITIONS
| Engine Type Conditions | Non-Engine Type Conditions |
|---|---|
| Engine Temperature | Ambient Temperature |
| Engine RPM | Moisture Conditions |
| Engine Load | Road Conditions (smooth-bumpy) |
| Engine idle/accel/deceleration |