LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Cooling System Specifications & Drive Belt Routing - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the bolts and the RH splash shield.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  4. Remove the bolt and the accessory drive belt tensioner.
    • To install, tighten to 45 Nm (33 lb-ft).
    5. NOTE: Refer to the illustration for correct drive belt routing.
    Fig 1: Removing Accessory Drive Belt Tensioner
    G03900405Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals