Drive Sprocket Alignment No 10 Thrust Washer Specifications
WARNING: This page is about a different variant/trim than selected.
DRIVE SPROCKET ALIGNMENT NO 10 THRUST WASHER SPECIFICATIONS
| Description | mm | inch |
|---|---|---|
| Drive sprocket-to-converter housing thrust washer AA | 1.51-1.41 | 0.059-0.052 |
| Drive sprocket-to-converter housing thrust washer BA | 1.77-1.67 | 0.069-0.065 |
| Drive sprocket-to-converter housing thrust washer CA | 2.03-1.93 | 0.079-0.075 |
| Drive sprocket-to-converter housing thrust washer DA | 2.29-2.19 | 0.090-0.086 |
| Distance measured during gauging procedure and appropriate thrust washer AA | 1.12-0.86 | 0.044-0.033 |
| Distance measured during gauging procedure and appropriate thrust washer BA | 0.85-0.60 | 0.033-0.023 |
| Distance measured during gauging procedure and appropriate thrust washer CA | 0.59-0.34 | 0.023-0.013 |
| Distance measured during gauging procedure and appropriate thrust washer DA | 0.33-0.08 | 0.012-0.003 |