On-Board Diagnostics With Diagnostic Tool
WARNING: This page is about a different variant/trim than selected.
NOTE:
For detailed instructions and other diagnostic methods using the diagnostic tool, refer to INTRODUCTION - GASOLINE
article for Escape (gasoline) and Mariner or INTRODUCTION- HYBRID ESCAPE
article for Escape (Hybrid) or diagnostic tool instruction guide.
NOTE:
If using a generic diagnostic tool, refer to INTRODUCTION - GASOLINE
article for Escape (gasoline) and Mariner or INTRODUCTION- HYBRID ESCAPE
article for Escape (Hybrid) article diagnostic tool instruction guide.
The Quick Tests can be used to diagnose the powertrain control module, sensors and actuators of this transaxle.
The following is a guide for using the on-board diagnostic (OBD) Quick Tests and the diagnostic tool.
- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On/Engine Off
- Quick Test 4.0 - Continuous Memory
- Quick Test 5.0 - Key On/Engine Running
- Special Test Mode
- Wiggle Test Mode
- Output Test Mode
- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other Diagnostic Tool Features
For additional information on other diagnostic testing features using the diagnostic tool, refer to INTRODUCTION - GASOLINE article for Escape (gasoline) and Mariner or INTRODUCTION- HYBRID ESCAPE article for Escape (Hybrid). Other diagnostic methods include the following:
- Parameter identification (PID) access mode, used to monitor sensors and actuators.
- Freeze frame data access mode, used to view emission-related data values from specific PIDs.
- Oxygen sensor monitor mode, used to monitor the oxygen sensor.