Removal and Installation
WARNING: This page is about a different variant/trim than selected.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Disconnect the radiator-to-degas bottle hose from the degas bottle.
- Disconnect the degas bottle-to-coolant bypass housing hose.
- Remove the 2 degas bottle nuts.
- To install, tighten to 6 Nm (53 lb-in).
- Lift the degas bottle up and disconnect the degas bottle-to-radiator hose.
- Remove the degas bottle.
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
All vehicles
2.3L vehicles
All vehicles