LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Climate Control) >> Removal And Installation >> High-Pressure Cutoff Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the high-pressure cutoff switch electrical connector.
  2. Remove the high-pressure cutoff switch.
    • Discard the O-ring seal.
  3. To install, reverse the removal procedure.
    • Install a new O-ring seal.
scientia non olet · About LEMON Manuals