LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 893 (Electronic Engine Controls - 2.3L - (Except Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the cylinder head temperature (CHT) sensor cover and position aside.
  2. Disconnect the CHT sensor electrical connector.
  3. Remove and discard the CHT sensor.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals