Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the electrical connector.

Fig 1: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the bolts.
- To install, tighten to 11 Nm (8 lb-ft).
Fig 2: Identifying Bolts
Courtesy of FORD MOTOR CO.
Disconnect the vacuum hose and remove the vacuum pump and bracket.

Fig 3: Removing Vacuum Pump And Bracket
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.