Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Spark plug wires must be connected in the correct firing order.

CAUTION: It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.

Fig 1: Pulling Spark Plug Wire Off Spark Plug

Courtesy of FORD MOTOR CO.

Using the special tool, with a twisting motion pull the spark plug wire off the spark plug.

NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.

Remove the spark plug.
- To install, tighten to 15 N.m (11 lb-ft).
Inspect the spark plug firing tip. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Adjust the spark plug gap as necessary.

Fig 2: Identifying Spark Plug Gap

Courtesy of FORD MOTOR CO.

NOTE: Apply silicone brake caliper grease and dielectric compound to the inside of the spark plug wire boots.

To install, reverse the removal procedure.