Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Position the watershield aside.
Remove the 3 rear door latch bolts.
- To install, tighten to 12 Nm (9 lb-ft).
Open the clip and disconnect the exterior rear door handle actuating rod.

Fig 1: Identifying Exterior Rear Door Handle Actuating Rod
Courtesy of FORD MOTOR CO.
Position the rear door latch aside.
Disconnect the 2 rear door latch electrical connectors and remove the rear door latch.
To install, reverse the removal procedure.
- Lubricate the rear door latch after installation.