LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 705 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Knock Sensor (KS) - 5.4L (3V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) article.
  2. Disconnect the knock sensor (KS) electrical connectors.
  3. Remove the bolts and the 2 KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals