LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Instrument Cluster And Panel Illumination) >> Diagnosis And Testing >> Instrument Cluster and Panel Illumination >> Pinpoint Tests >> Pinpoint Test A: The Control Illumination Is Inoperative >> Pinpoint Test A: The Control Illumination Is Inoperative

Pinpoint Test A: The Control Illumination Is Inoperative

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 CHECK THE EXTERIOR LAMP OPERATION 
    • Place the headlamp switch in the parking lamps on position.
    • Are the parking lamps illuminated? 

    Yes:  GO to  A2.

    No:  REFER to PARKING, REAR AND LICENSE PLATE LAMPS to continue diagnosis of the parking lamps.

  2. A2 CHECK FOR CORRECT SJB OPERATION 
    • Disconnect all the SJB connectors.
    • Check for:
      • corrosion
      • pushed-out pins
    • Connect all the SJB connectors and make sure they seat correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 

    Yes:  INSTALL a new SJB. REFER to REMOVAL AND INSTALLATION . TEST the system for normal operation.

    No:  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.

scientia non olet · About LEMON Manuals