Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear bumper cover. For additional information, refer to Bumper Cover - Rear .
- Remove the 3 rear air deflector bolts.
- If equipped, remove the parking aid module and bracket assembly.
- Remove the 5 parking aid module bracket bolts.
- To install, tighten to 12 Nm (9 lb-ft).
- Disconnect the parking aid module electrical connector.
- Remove the 5 parking aid module bracket bolts.
- Remove the 4 nuts (2 each side) and the rear bumper.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.