LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Electronic Engine Controls - Diesel Engine) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
  3. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals