LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Electronic Engine Controls - Diesel Engine) >> Removal And Installation >> Barometric Pressure (BARO) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Remove the instrument panel steering column cover.
    3. Fig 1: Steering Column Opening Cover
    GF0012082Courtesy of FORD MOTOR CO.
  3. Disconnect the pin-type retainer and position the barometric pressure (BARO) sensor out of the dash.
    4. Fig 2: Identifying Barometric Pressure (BARO) Sensor
    GF0044617Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector and remove the BARO sensor.
    5. Fig 3: Identifying Electrical Connector
    GF0044618Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals