LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1095 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Latch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the screw and slide the interior door handle forward to disengage the tabs from the door.
  3. Position the water shield aside.
  4. Release the cable conduit from the interior door handle, then slide the cable end from the door handle pivot.
    5. Fig 1: Cable End At Door Handle Pivot
    GF0011457Courtesy of FORD MOTOR CO.
    NOTE: Use the special tool to install the new latch assembly rivet.
  5. If equipped, remove the door lock actuator rivet.
  6. Disconnect the door lock cylinder actuating rod.
  7. Disconnect the exterior door handle actuating rod.
  8. Remove the front door latch screws.
    • To install, tighten to 12 Nm (9 lb-ft).
  9. Disconnect the door lock actuator electrical connector.
  10. Remove the front door latch assembly.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals