Pinpoint Test B: Clutch Chatter Or Shudder
WARNING: This page is about a different variant/trim than selected.
- B1 CHECK THE ENGINE AND TRANSAXLE MOUNTS
- Inspect all engine and transaxle mounts for looseness or damage. Refer to ENGINE - 2.3L A, if necessary.
- Are any of the engine or transaxle mounts loose or damaged?
- Yes : TIGHTEN or INSTALL new engine mounts or transaxle mounts.
- No : GO to B2.
- B2 INSPECT THE CLUTCH PRESSURE PLATE
- Remove the clutch disc. Refer to CLUTCH .
- Inspect the clutch pressure plate and diaphragm springs for wear and even diaphragm height.
- Are there any signs of wear present on the clutch pressure plate?
- Yes : INSTALL a new clutch pressure plate. REFER to CLUTCH .
- No : GO to B3.
- B3 CHECK THE CLUTCH DISC
- Inspect the clutch disc for any signs of damage.
- Is the clutch disc OK?
- Yes : INSPECT the flywheel for damage. REFER to FLYWHEEL RUNOUT CHECK .
- No : INSTALL a new clutch disc. REFER to CLUTCH .