Shift Concerns: Some Or All Shifts Missing

WARNING: This page is about a different variant/trim than selected.

DIAGNOSTIC ROUTINES - SHIFT CONCERNS SOME OR ALL SHIFTS MISSING

Possible Component	Reference/Action
210 - ELECTRICAL ROUTINE
Powertrain Control System
	Carry out Shift Point Road Test. Refer to SHIFT POINT ROAD TEST .
Electrical inputs/outputs, vehicle wiring harnesses, powertrain control module (PCM), shift solenoids, transmission range (TR) sensor, throttle position (TP) sensor, output shaft speed (OSS) sensor, TCS	Run On-Board Diagnostics Tests. Refer to INTRODUCTION - GASOLINE article for Escape (gasoline) and Mariner or INTRODUCTION- HYBRID ESCAPE article for Escape (Hybrid). GO to PINPOINT TEST A and GO to PINPOINT TEST D .
310 - HYDRAULIC/MECHANICAL ROUTINE
Fluid
Incorrect level	Fill to correct level.
Internal and External Shift Linkages
Damaged, out of adjustment, misassembled or internal linkage disconnected.	Inspect and repair as necessary. Verify linkage adjustment. Refer to AUTOMATIC TRANSAXLE-TRANSMISSION EXTERNAL CONTROLS - CD4E . After repairing linkage, verify that the transmission range (TR) sensor is correctly adjusted.
For diagnosis related to a specific gear use diagnostic tool to determine gear	Refer to the following shift routine(s) for further diagnosis:
Shift Concern: No 1 - 2 Shift	Routine 220/320
Shift Concern: No 2 - 3 Shift	Routine 221/321
Shift Concern: No 3 - 4 Shift	Routine 222/322