Other Concerns: No Engine Braking In Manual 1ST Position

WARNING: This page is about a different variant/trim than selected.

DIAGNOSTIC ROUTINES - OTHER CONCERNS NO ENGINE BRAKING IN MANUAL 1ST POSITION

Possible Component	Reference/Action
258 - ELECTRICAL ROUTINE
Powertrain Control System
Electrical inputs/outputs, vehicle wiring harnesses, powertrain control module, 3-2 timing/coast clutch solenoid	Run On-Board Diagnostics Tests. Refer to INTRODUCTION - GASOLINE article for Escape (gasoline) and Mariner or INTRODUCTION- HYBRID ESCAPE article for Escape (Hybrid). GO to PINPOINT TEST G .
358 - HYDRAULIC/MECHANICAL ROUTINE
Main Controls
Bolts out of specification	Adjust bolts to specification.
Gaskets damaged	Inspect for damage. Repair as necessary.
Low/reverse modulator valve, coast clutch valve stuck, damaged or misassembled	Inspect for damage. Repair as necessary.
3-2 timing/coast clutch solenoid stuck or damaged	Inspect for damage, contamination. Activate solenoid using the Transmission Tester. Repair as necessary.
Hydraulic passages damaged	Inspect for damage. Repair as necessary.
Pressure tap plate/gasket damaged	Inspect for damage. Repair as necessary.
Separator plate/gasket damaged	Inspect for damage. Repair as necessary.
Coast Clutch Assembly
Assembly misassembled, damaged	Inspect for damage. Repair as necessary.
Forward clutch hub seal damaged	Inspect for damage. Repair as necessary.
Piston or seals damaged	Inspect for damage. Repair as necessary.
Check ball damaged, missing	Inspect for damage. Repair as necessary.
Low/Reverse Clutch Assembly
	Carry out Air Pressure Test.
Assembly misassembled, damaged	Inspect for damage. Repair as necessary.
Piston or seals damaged	Inspect for damage. Repair as necessary.
Pump Assembly
Pump support No. 2 or No. 3 seal rings for the coast clutch circuit damaged, missing	Inspect for damage. Repair as necessary.