Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the liftgate window glass is in the raised position.

Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
Disconnect the liftgate window latch.
1. Disconnect the liftgate window latch ajar switch electrical connector.
2. Open the clip and disconnect the actuating rod.

Fig 1: Liftgate Window Latch Ajar Switch Electrical Connector & Actuating Rod

Courtesy of FORD MOTOR CO.

NOTE: Mark the position of the liftgate window latch prior to removing the liftgate window latch bolts.

Remove the 2 bolts and the liftgate window latch.
- To install, tighten to 12 Nm (9 lb-ft).

Fig 2: Liftgate Window Latch Bolts

Courtesy of FORD MOTOR CO.

NOTE: The liftgate window latch must be checked to make sure the latch is installed and aligned correctly.

To install, reverse the removal procedure.