LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 881 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate - Hybrid >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the battery junction box (BJB) fuses 24 (50A) and 31 (50A).
  3. Remove the brake pads. For additional information, refer to Brake Pads .
  4. Remove the 2 brake caliper anchor plate bolts.
    • To install, tighten to 175 Nm (129 lb-ft).
  5. Remove the brake caliper anchor plate.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals