LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 804 (Steering Column - F250-F550) >> Removal And Installation >> Steering Wheel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel to the straight-ahead position and turn the ignition switch to the OFF position.
  2. Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
  3. Remove and discard the steering wheel bolt.
    • To install, tighten to 38 Nm (28 lb-ft).
    4. CAUTION: Removing the steering wheel without using a puller can damage the column bearings.
    Fig 1: Removing Steering Wheel Using Special Tool
    GF0007792Courtesy of FORD MOTOR CO.
  4. Using the special tool, remove the steering wheel.
    • Remove the steering wheel while routing the wires from the clockspring through the steering wheel.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals