LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 750 (Anti-Theft System) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN article.
  2. Remove the 2 bolts and the lower steering column shroud.
    3. NOTE: Vehicles with a steering column shift are shown; the floor console shift is similar.
  3. Remove the ignition lock cylinder cover.
  4. Disconnect the PATS transceiver electrical connector.
  5. Remove the screw and the PATS transceiver.
    6. NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the powertrain control module (PCM) again.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals