Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition coil-on-plug. For additional information, refer to Ignition Coil-On-Plug .
- Remove the spark plugs.
- To install, tighten to 15 Nm (11 lb-ft).
- Inspect the spark plugs. Install new spark plugs as necessary. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
- To install, reverse the removal procedure.
NOTE:
Use compressed air to remove any foreign material from the spark plug well before removing the spark plugs.
NOTE:
If an original spark plug is used, make sure it is installed in the same cylinder from which it was taken. New spark plugs can be used in any cylinder.