Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The bolt covers are one time use only.

Remove the assist handle bolt covers.
- To remove, start at the handle side of cover and work outward.

Fig 1: Removing Assist Handle Bolt Covers

Courtesy of FORD MOTOR CO.

Remove the assist handle bolts.
- To install, tighten to 7 Nm (62 lb-in).
Remove the A-pillar trim panel.
To install, reverse the removal procedure.