LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Escape Hybrid, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 712 (Windows And Glass - F-150 & Mark LT) >> Removal And Installation >> Window Glass - Rear Door, SuperCab >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Remove the rear door mounted speaker. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS article.
  3. Remove the rear door interior moulding.
  4. Remove the rear door watershield.
  5. Remove the C-pillar below belt bracket bolt and bracket.
    • Slide bracket down to disengage from U-channel in door.
    • To install, tighten to 10 Nm (89 lb-in).
  6. Remove the B-pillar below belt bracket bolt and bracket.
    • To install, tighten to 10 Nm (89 lb-in).
    7. NOTE: Some vehicles may use rivets instead of rear door window glass-to-regulator assembly bolts.
  7. Remove the rear door window glass-to-regulator assembly bolts.
    • To install, tighten to 11 Nm (8 lb-ft).
  8. Remove the rear door window glass.
    • Pull the rear door window glass out through the top inboard side of the door.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals